cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Your Friends List is a way to easily have access to the community members that you interact with the most! X

Unit of Measure In Creo 2.0

canderson
6-Contributor

Unit of Measure In Creo 2.0

How to you change from mm to inch in Creo View 2.0

7 REPLIES 7

Open the part or assembly and go to File/Prepare/Model Properties/Units - change

There are some config options pro_units_length and pro_units_mass

The idea is that you want to open templates that are already set the way you want, but File/Prepare/... will let you change it.

canderson
6-Contributor
(To:canderson)

Sorry left off an important detail... CREO VIEW 2.0

D'OH!

File - Options - Defaults - General - Units

CV+Units.jpg

Anyone here know how to change the default/startup units from inches to mm. WITHOUT uninstalling the software and re-installing it.

Thanks

Dale_Rosema
23-Emerald III
(To:ptc-4766099)

David,

Take a look at this post:

http://communities.ptc.com/message/188248#188248

Thanks, Dale

Check this out http://bit.ly/1eHupI3

Thanks,

Madhavi

Announcements


Top Tags