how to open a part from a drawing view/BOM table in Creo View
Jul 16, 2024
09:33 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Jul 16, 2024
09:33 AM
how to open a part from a drawing view/BOM table in Creo View
Would it be possible to be able to open a 3D model of a part/subassembly in creo view from a drawing/BOM table also in creo view? If not is there any other PTC software (other than parametric or any of the actual modelling softwares) that could do such a thing? (Currently using Creo View Express 11.0)
1 REPLY 1
Jul 22, 2024
07:49 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Jul 22, 2024
07:49 AM
Hi @JosephTC ,
Thank you for your question.
Your post appears clear but has not yet received any response. I am replying to raise awareness. Hopefully, another community member will be able to help.
Also, feel free to add any additional information you think might be relevant. It sometimes helps to have screenshots to better understand what you are trying to do.
