Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X
Hello. I am designing a electronics chassis that is going to be tested on a shake table. My issue is what are the proper boundary conditions? I have been doing this for a long time and before I just constrained the bottom surface of the chassis. I have gone through several different variations of BC's Now, I just constrain the bolt holes that are around the edge of the chassis. I am still not happy/comfortable with them. See attached picture of model.
Anyone else have any experience or thoughts to the proper BC's.?
Thanks in advance