Creo 4.0 student ed. Error - "Unable to get required Creo Simulate license."
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Creo 4.0 student ed. Error - "Unable to get required Creo Simulate license."
Hi, I downloaded Creo 4.0 student edition a few days ago and had no problems, I even used it an hour ago and had no problems. I just tried using creo again and when I try to open creo I get the error - "Unable to get required Creo Simulate license. Please contact your sales representative." Haven't found much online so I thought i'd ask here. Any help is appreciated.
- Labels:
-
General
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Hi,
I think you cannot launch Creo Simulate as standalone application.
Launch Creo parametric, open model and switch to Simulate application on Application tab.
Martin Hanák
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Run reconfigure.exe from Creo Simulate 4.0 loadpoint and make sure the following License type are available
MEC_BASIC_UI MECBASICUI_License
MEC_BASIC_ENG MECBASICENG_License
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Hi,
just FYI Student licence does not contain any Simulate license.
Martin Hanák
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
i CANT GET
MEC_BASIC_UI MECBASICUI_License THESE TWO LICENCE
HOW CAN I GET
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Student License does not have simulation capabilities