cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - You can subscribe to a forum, label or individual post and receive email notifications when someone posts a new topic or reply. Learn more! X

Creo Ansys Simulations fails to complete an analysis

NiloyGuha
6-Contributor

Creo Ansys Simulations fails to complete an analysis

I am using Creo Parametric 8.0 8.0.0.0

Analysis fails after mesh is created and 99% of the FEA is completed of a fairly complex assembly. The same assembly has been successfully analysed in Creo Simulate.
1 ACCEPTED SOLUTION

Accepted Solutions
NiloyGuha
6-Contributor
(To:DaveMartin)

Hi Dave,

 

The issue got resolved in Creo 9.0.1.0. There was a problem in the previous versions of Creo Ansys Simulation.

 

Regards,

Niloy

View solution in original post

8 REPLIES 8
NiloyGuha
6-Contributor
(To:NiloyGuha)

The error message is attached.

Opened C15883128

NiloyGuha
6-Contributor
(To:hhiller)

A SPR has been filed as the error has been replicated by PTC tech support. So now we need to wait for them to figure out the cause of the error.

That link no longer works.

Dave Martin - dmartin@creowindchill.com - https://www.mcaeconsulting.com
NiloyGuha
6-Contributor
(To:DaveMartin)

Hi Dave,

 

The issue got resolved in Creo 9.0.1.0. There was a problem in the previous versions of Creo Ansys Simulation.

 

Regards,

Niloy

I got it also in Creo 9.0.4.0

 

 

 

NiloyGuha
6-Contributor
(To:ProFeature)

That could be some other problem as the specific problem that I had faced in Creo 8 was finally resolved in Creo 9.0.1.0.

 

Regards,

Niloy

Top Tags