I am trying to use the updated Manikin models. When I try to move the manikin model Creo requires that I have access to some of the sub-models. This makes using the manikin models more challenging. I can move the manikin model around, but if I try to edit a joint, then manikin requires access to the lower level assemblies. If all the models are read only, I can't continue. The manikin model should need to write access to these lower level assemblies.
Manikin_Adjust.mp4
Video Player is loading.
Current Time 0:00
/
Duration 0:00
Loaded: 0%
0:00
Stream Type LIVE
Remaining Time -0:00
1x
Chapters
descriptions off, selected
captions settings, opens captions settings dialog
captions off, selected
This is a modal window.
Beginning of dialog window. Escape will cancel and close the window.
End of dialog window.
This is a modal window. This modal can be closed by pressing the Escape key or activating the close button.
Some of the lower level assemblies contain "packaged" components. I understand this is not best practice, but probably should stop me from moving the manikin arm. Will probably submit a ticket to report the fault.
Some of the lower level assemblies contain "packaged" components. I understand this is not best practice, but probably should stop me from moving the manikin arm. Will probably submit a ticket to report the fault.
