Gents and Ladies
I'm a relative neewbie to the joys of ProE... I am trying to create spring models for insertion into assemblies. I can and have sucessfully created springs using helical commands, however, I want to create closed section springs with ground ends, this is where I am struggling.
i.e. the springs have a cirlcular contact with a surface rather than a piont contact.
Thanks in anticipation
Stuart
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
