I'm beginning the get the feeling that Pro E doesn't like change. Can anyone tell me what is the right way to do this? I have piece of piping equipment with ports setup on it, and I have run piping from that item to various other places. Engineering tells me they want a size smaller on that equipment. So, I do a famous save-copy-as deal and create my new object, complete with ports. I go back to my assembly and do a replace on the original item, which (as expected) causes the start point of my pipeline to go away (lost references). I expected that. But when I attempt to redefine the start point to the port on the replaced equipment, I am immediately looking at my desktop. No warning, no error messages... just goodbye! And then i get to do the whole thing over again... and again etc.
Help?
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
Chris Benner
Autodesk ® Expert Elite
