Optional Simulations on Mold Analysis cannot seen
‎Dec 01, 2022
05:27 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
‎Dec 01, 2022
05:27 AM
Optional Simulations on Mold Analysis cannot seen
On the mold flow analysis setup tab, I cannot see optional simulations tab which involves sink mark simulation check. I want to make a sink mark check for a part but since I cannot check this box, I cannot reach any results.
Solved! Go to Solution.
Labels:
- Labels:
-
Creo Simulation Live
ACCEPTED SOLUTION
Accepted Solutions
‎Dec 02, 2022
03:47 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
‎Dec 02, 2022
03:47 AM
Hi,
Creo Simulation Live does not belong to Mold Analysis.
Martin Hanák
3 REPLIES 3
‎Dec 01, 2022
06:30 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
‎Dec 01, 2022
06:30 AM
Please specify which version of the program you are using.
‎Dec 01, 2022
06:47 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
‎Dec 01, 2022
06:47 AM
it is 7.0.2.0
‎Dec 02, 2022
03:47 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
‎Dec 02, 2022
03:47 AM
Hi,
Creo Simulation Live does not belong to Mold Analysis.
Martin Hanák