I apologize if this might have been asked before:
Every time I try to use "erase not displayed" function and then try to open
another part/assembly, ProE crashes! It's gotten to the point that instead
of using "erase not displayed" I just shut down ProE and restart!
I'm on Wildfire 2.0, XP, with P IV, 2.7GHz, 1GB RAM
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.