RES: rib tool

[grocha]

It is simple,



Create a sketch that illustrate the rib profile,







Than it, click on rib tool and select the sketch. Done!!!



If you had any other question please contact us.



Best regards,

Paulo Zocchio - Suporte PLM
PLM Solutions do Brasil
O Representante Estratégico da PTC no Brasil
Tel. 0800-701-9730
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

[HugoHermans]

The sketch has to be open, and start and end point has to be attached to the solid geometry.

Regards, Hugo.
"Paulo Zocchio" <suporte@plmbrasil.com.br> wrote in message news:214335@model...
It is simple,



Create a sketch that illustrate the rib profile,







Than it, click on rib tool and select the sketch. Done!!!



If you had any other question please contact us.



Best regards,

Paulo Zocchio - Suporte PLM
PLM Solutions do Brasil
O Representante Estratégico da PTC no Brasil
Tel. 0800-701-9730