cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Did you know you can set a signature that will be added to all your posts? Set it here! X

Screw modeling Creo Simulate

DT_10279004
4-Participant

Screw modeling Creo Simulate

Good morning, beacause I am a newbe in Creo Simulate I need a help for modelig hinges screws.
I have a 3D mechanical frame where connection are made by hinges and screws. For the hinges, following the description in the description in these links

https://community.ptc.com/t5/3D-Part-Assembly-Design/Hinge-Deflection-Simulation/td-p/94974
https://www.ptc.com/en/support/article/CS349520

the procedure is described below:

- put 3 points for my beam elements (two at the edges and and one at the middle span) - Image 1
- I created my two beam elements using the Point-Point Pairs option - Image 2
- set rotation releases in the edges of every element - Image 3
- set rigid links between the points and the inner surfaces of the holes - Image 4

At this point I need to understand:

- has the hinge been well modeled?
- can I model screws in the same way, just removing the rotation releases?

Many thanks in advance

2 REPLIES 2

att. my example for hinge

(but not for screw)

DT_10279004
4-Participant
(To:skunks)

Thank you skunks! 

Announcements


Top Tags