Good morning,
I am performing a cyclic symmetry simulation studying 1/4 of a component exploiting cyclic symmetry.
As output I requested the reaction torque on the constrained face: this output is related to the portion I am simulating or does it take into account the whole component (so it is referred also to the other 3/4 face I do not see in the model because I am working just on 1/4)?
Thank you very much.
Regards,
Claudia
a example attached:
M=F*r*360/30=1kN*60mm*12=720Nm
Measure: M=2000N*30mm*360/30=720Nm