We are working to address an issue with subscription email notifications. In the meantime, be sure to check your favorite boards for new topics.
Anyone have an idea on how to set motion up for Sphericaly released cylinders.
I keep getting an error due to the rotation to the cylinder.
I am also getting an error on my gimbal. I want it locked out so it can't spin. Want the range of motion locked to 12 Degrees.
I have tried having Sub-Assemblies (Cylinders and Gimbal) and all components in one file. I just can't get this one to work.
Gif of motion I want. (Forgive me for the poor dragging)
I actually want to move the cylinders thru the sweep ranges and make a motion sweep of the area.
Any Help is much appreciated.
Gif and Dummy Files attached.
I recommend changing your 4 gimbals to match your center X connection.
Each gimbal would then have two pin joints and a dummy part for the X.
To make your motion, record the cylinder extensions at each of the points you want to reach then use a tabulated servo motor to control each cylinder.