11 Replies 3006 Views
Hello everybody,I wonder how can I make a function (for torque motors and others) like this:f(theta)...
Hi Everyone, I am looking for a way to essentially generate a graph of force balance (i.e. input and...
(view in My Videos)
dynamic friction 0,05 (view in My Videos)
Hi, I have a Beam idealization helt at three points, at the ends and in the middle. I then perform a...
grey cast iron cap what is wrong?
Hello I am new to mechanism. Can anyone guide me for sample tutorial on the same? I would like to st...
Hello, When using the Fluid Analysis i always get the message "Residual is NaN!" after pressing exec...
I'm hoping someone can help me with this...I'm fairly new to Creo simulate... I am trying to simulat...
4 Replies 11061 Views
I'm using a Lenovo Thinkpad T430s running Windows 7 Enterprise, Service Pack 1. I installed Creo, bu...
(view in My Videos)
Hello, I have a simple mechanism with no interference and I had defined a 3D contact on it. I run th...
4 Replies 1209 Views
I'm trying to analyse a shaft with various components assembled on it. One of those is a nut, which ...
1. using parts supplied in differential_parts (STEP for those who do not have CREO 5) 2. assemble th...
9 Replies 1311 Views
Hi, I am running a modal analysis of some componentes on PTC CREO Simulate. But the results produced...
Hello, Can You Help Me How to use these parameters? These data are used to analize the model? Thank ...
Make rotate the follower connected to cam in clock wise direction for some angle continued with anti...
I am new to using Creo 2.0 and am looking for some help on this issue. I would like to show that my ...
Good morning,I subjected a ring to four forces.I can't put a fixation constraint.So I used the Inert...
Hello, How I can insert a fastener in this condition? Maybe I could use the washer from 3D or there ...
hi, is it possible to display stresses in creo simulate 4 or 5 over the cross-section of a beam anal...