hexa mesh not created - why?

[rrakos]

Hello,

I tried to create mapped hexamesh for a full symmetric geometry. The first side was OK, but the second side is not. Error nitice can be seen at picture:

The two mesh region is total same. What is the reason of this errror?

Thanks

Roland

[SweetPeasHub]

Can you compress the file to a .zip and attach it?

[rrakos]

File is attached.

Thanks

R.

[gfraulini]

Hi,
I made the volume region attached to the geometry and not to the plane.

Bye

[rrakos]

What is your creo version?

[gfraulini]

Creo 5.0.3

[SweetPeasHub]

Try changing your part accuracy to 0.001 instead of 0.005.  It has something to do with the accuracy of the spline.

Also these images demonstrate how to map the mesh.  I prefer to use all points/vertexes.Mapped Regions

Points for mapped regions

[skunks]

hm...

[SweetPeasHub]

Yes of course symmetry is nice and I omitted the fillets.  I am hoping the accuracy change is what solves the problem because I could not map until I did the accuracy change to 0.001mm

[skunks]

please check the sketch 1

[rrakos]

The sketch 1 is a simple and closed contour. What should I check on it?

[skunks]

[skunks]

[skunks]