how to using Creo MDO 3D contact

[ptc-3977032]

Such as pictures, 3D contact tool Get used to using.

I want to use the analysis.

Is caught flat surface.

As shown in the figure, the rotation of the surface modeling is not recognized.

Is there another way?

This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

[bp]

Hi,

3d contact can only handle flat surfaces connected to rounds (or datum points).

You have to define a flat surface on the cone, you can then hide the surface (which is not a solid).

tips:

- assign a material to all individual parts.

- Only assign 3d contacts where its really needed.

- regenerate before starting analysis

- use higher frame-rate for better results

I hope 3d contact will be a lot more user friendly in CREO 3..

good luck.

Video Link : 4650