cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X

Assembly global parameter problem

asingh-7
1-Newbie

Assembly global parameter problem

hi all,

I am facing a problem please try to help me out.

I have a main assembly which have two sub assemblies. I have some parameters in main assembly, as per my main assembly parameter, sub assembly "A" and sub assembly "B" should update respectively. In short if i say, i require a global parameter type functionality. But as per my knowledge that we can do only in "LAYOUT" which i can not use in assembly. This is the restriction for me.

Please share me your valuable idea or provide me process if we can create global parameter in assembly.

I have attached supported snap shot.

Thanks,

Ashish Singh


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
1 REPLY 1

Hi,

see parameters and relations in example data (created in CR2 M070).

MH


Martin Hanák
Top Tags