Pro's I have a sheet metal bracket with some slots that have been mirrored, the original slots have axis's in the center of the slot. I'm using this bracket in an assembly, and need to use the mirrored slots and need axis's in the center. Is there a way to create axis in the center of these mirrored slots. Thanks for any suggestions. Robert Parsons Designer Gilbarco Veeder-Root 7300 Friendly Ave. Greensboro, NC. 27409 Phone 336-547-5604
This message (including any attachments) contains confidential and/or proprietary information intended only for the addressee. Any unauthorized disclosure, copying, distribution or reliance on the contents of this information is strictly prohibited and may constitute a violation of law. If you are not the intended recipient, please notify the sender immediately by responding to this e-mail, and delete the message from your system. If you have any questions about this e-mail please notify the sender immediately.