cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - If community subscription notifications are filling up your inbox you can set up a daily digest and get all your notifications in a single email. X

Cannot modify attachement of balloon with Pro/Cable

ShandRonnie
5-Regular Member

Cannot modify attachement of balloon with Pro/Cable

Once I show a balloon in a Pro/E drawing that has a cable assembly I cannot modify the attachement of the balloon to the surface portion of the cable (Pro/Cables are different than Pro/Piping in that they are not solid geometry but surfaces.


Balloons can be attached to the entity ot to surfaces, but with a cable I cannot select the surface nor the edge of the cable to set the tip of the arrow from the balloon.


I could create a datum point at the location of the cable where I want to point to, but it is not a clean approach.


Any tips are welcome,


Thanks,
Ronnie Shand


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
0 REPLIES 0
Top Tags