cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X

Hey all PTC champs...need help...i am not able to find New featuer i.e Security marking In Creo 3.O

dyadav
7-Bedrock

Hey all PTC champs...need help...i am not able to find New featuer i.e Security marking In Creo 3.O

Hey all PTC champs...need help...i am not able to find New featuer i.e Security marking In Creo 3.O

How to activate that...

Name of feature may be " Security Marking 3d Animation" it is used for drawing- formatt to asign any note as security mark..

Also Anyone used freestyle modeling....when I using that 3d Dragger it not smoot as like Creo 2.O....It is bug or any setting should be there???


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
1 ACCEPTED SOLUTION

Accepted Solutions
mganzer
1-Newbie
(To:dyadav)

Remember this is only for "Notes and Symbols" and "NOT Annotation Features".

SECURITY MARKING.jpg

View solution in original post

9 REPLIES 9
Mahesh_Sharma
22-Sapphire I
(To:dyadav)

Dinesh,

Security marking is available in format tab enabled after creation of note (Annotate Tab) in model.

TomU
23-Emerald IV
(To:Mahesh_Sharma)

Mahesh Sharma‌, where is this documented?

TomU
23-Emerald IV
(To:Mahesh_Sharma)

I've managed to find the following blurb in CS130154. I'm not seeing anything in the help documentation. Is there anything else?

Security Markings for 3D Annotations

  • Support for ASME Y14.41-2003
    • Ability to have a security marking permanently displayed
  • Notes and Symbols placed Flat to Screen can be designated as Security Marking
    • Only standalone annotations supported, NOT Annotation Features
  • These annotations will be added to all combination states
  • They will be permanently visible when published to PTC Creo View
dyadav
7-Bedrock
(To:TomU)

That is what I am asking icon of Security marking is not found in Format tab also.....when i am creating any note in format tab it should be there but not found

That is what I am asking icon of Security marking is not found in Format tab also.....when i am creating any note in format tab it should be there but not found

Mahesh_Sharma
22-Sapphire I
(To:dyadav)

Dinesh,

1. Create a note in model

2. After completing note creation, annotate > select note > activate format tab > security marking.

mganzer
1-Newbie
(To:dyadav)

Remember this is only for "Notes and Symbols" and "NOT Annotation Features".

SECURITY MARKING.jpg

TomU
23-Emerald IV
(To:mganzer)

I wonder why it only works using the "old method" of creating annotation features. (See Brian's comments on this here:Re: 3D Annotations VS 3D Annotation Features)

dyadav
7-Bedrock
(To:mganzer)

Sorry Late to this....Thank You for your...will try and update you

Top Tags