cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - You can change your system assigned username to something more personal in your community settings. X

How to apply variables to an assembly?

EdCouch
1-Newbie

How to apply variables to an assembly?

Is there a tutorial that gives instructions on how to apply variables to an assembly? The

assembly grows in height and width?


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
3 REPLIES 3

Hi Ed, Check out LearningExchange, http://learningexchange.ptc.com, it's a new site from PTC University which offers free short tutorials on how to do something in PTC products. If you don't find what you're looking for, feel free to use the "contact us" link at the bottom of the page and make suggestions on what you would like to see!

I found one called ProE/Program Primer. It was a good place to start. But I realized

that I needed to locate some information on the syntax required to use it. I also need

to figure out how to establish dimension labels.

I wish I could help, but syntax and dimension labels are not in my area of expertise. Hopefully another member can assist.

Top Tags