cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Stay updated on what is happening on the PTC Community by subscribing to PTC Community Announcements. X

How to split a table?

raviles
4-Participant

How to split a table?

Folks,

This question applies to both drawing and manufacturing, so I thought I'd post it here.

I have a machine tool with a large table that's split into two zones, A & B. Programs are written per zone. I have a manufacturing assembly that has two operations, A & B as can be seen in the attached picture. All of the required information is shown, but I'd like it split into two separate tables.

I guess that the repeat region would have to be set to work with a specific operation, but I'm not sure how to do this, or if it's even possible.

Any feedback would be greatly appreciated.

Best regards,

Ray Aviles


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
1 ACCEPTED SOLUTION

Accepted Solutions
raviles
4-Participant
(To:raviles)

Folks,

OK, I have an answer to my own question. It seems that the thing to do is to use two identical tables, and filter out the unwanted item, which in this case was one of the operations.

I guess it helps to read the manual 😉

Best regards,

Ray Aviles

View solution in original post

1 REPLY 1
raviles
4-Participant
(To:raviles)

Folks,

OK, I have an answer to my own question. It seems that the thing to do is to use two identical tables, and filter out the unwanted item, which in this case was one of the operations.

I guess it helps to read the manual 😉

Best regards,

Ray Aviles

Top Tags