cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

MAss and CG analysis in a large assembly

SOLVED
Highlighted
Garnet

MAss and CG analysis in a large assembly

I am running CREO 3.0 M090

I have a large assembly with multiple sub-assemblies.

I have a total of around 2000 parts in this large assembly.

Of the 2000 parts, 1500 are reference only and 500 are real, or new, parts.

 

How can I run a Mass an CG analysis on only the 500 real parts and not include the 1500 reference only parts?

1 ACCEPTED SOLUTION

Accepted Solutions

Re: MAss and CG analysis in a large assembly

Make a simplified rep of just the parts you want mass/cg on. Then run mass properties on that.

Stephen Williams
Pro/E Version 15/16 (Circa 1995/1996)
2 REPLIES 2

Re: MAss and CG analysis in a large assembly

Make a simplified rep of just the parts you want mass/cg on. Then run mass properties on that.

Stephen Williams
Pro/E Version 15/16 (Circa 1995/1996)

Re: MAss and CG analysis in a large assembly

Stephen,

 

Thanks for the tip.

 

I will try it and reply