cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - You can subscribe to a forum, label or individual post and receive email notifications when someone posts a new topic or reply. Learn more! X

PCB assembly EMN/EMP import does not create holes.

mescalante
4-Participant

PCB assembly EMN/EMP import does not create holes.

How can I import the holes into a PCB assembly using the IDF import?  If I open the board alone, I am able to import the holes but I cannot do it within the assembly.  Is there a setting I need to set?


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
1 ACCEPTED SOLUTION

Accepted Solutions

If the holes appear when you are in the board alone then the config options must be set correctly.  To update the board while it is in the assembly you will have to activate the board and then do you import of the IDF file.  No board changes will happen when the assembly itself is activated when importing the IDF file.  Just component placement.

View solution in original post

2 REPLIES 2
mescalante
4-Participant
(To:mescalante)

I am using Creo 3 M060 build.

If the holes appear when you are in the board alone then the config options must be set correctly.  To update the board while it is in the assembly you will have to activate the board and then do you import of the IDF file.  No board changes will happen when the assembly itself is activated when importing the IDF file.  Just component placement.

Top Tags