cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - If community subscription notifications are filling up your inbox you can set up a daily digest and get all your notifications in a single email. X

Pro/E assembly color

Moultrie
1-Newbie

Pro/E assembly color

I have all the individual parts in my assembly colored and in the assembly. I changed the color of a sub assembly and I cannot get the assembly to reinherit each individual parts color. I have searched the help center and cant find anything. Any help is appreciated.


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
1 ACCEPTED SOLUTION

Accepted Solutions

Hi Thomas,

Are you in WF5?

If so have a look at the top of the Appearance Tool The second line down has a drop box that has "Clear Appearance" in it. Click on the drop arrow and select "Clear All Appearances". Fingers crossed; this should work.

Regards, Brent Drysdale

View solution in original post

3 REPLIES 3

I cannot even figure out how to color each individual component in the assembly, it automatically colors each subassembly as a whole.

Hi Thomas,

Are you in WF5?

If so have a look at the top of the Appearance Tool The second line down has a drop box that has "Clear Appearance" in it. Click on the drop arrow and select "Clear All Appearances". Fingers crossed; this should work.

Regards, Brent Drysdale

Brent,

I cannot thank you enough for this! This was driving me insane and I needed the appearances cleared by today. Thank you again!

Moultrie

Top Tags