cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Did you know you can set a signature that will be added to all your posts? Set it here! X

Requirement of an automated tool to study the overlayed Creo model and a SW model in an assembly environment

psimha
1-Newbie

Requirement of an automated tool to study the overlayed Creo model and a SW model in an assembly environment

Hello,

Is there any automated tool through which one can study the overlayed Creo model and a solid works model in Creo assembly environment. The basic intent of this test would be to check the Creo model against the standard solid works model, so that, the geometry of the Solid works model and that of the Creo model match perfectly if there are no errors in the Creo model.


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
1 REPLY 1
hdasilva
13-Aquamarine
(To:psimha)

Hi

Have you tried to use the Compare Part tool?

Comp.png

I don't know if it works with SW Models... but if you convert it into a step it works.

You just have to set the tolerance.

comp..png

Top Tags