cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

The exploded view is getting lost in snapshot mode. How can i retrieve this?

Highlighted
Newbie

The exploded view is getting lost in snapshot mode. How can i retrieve this?

Hi,

I have an assembly and there is very much component in it. I took a snapshot and exploded this snapshot in order to show it on drawing. I complated all of these steps. Everything is allright so far.

But,

I needed to add a component to my assembly. And i updated snapshot because of this new component. Then i wanted to edit exploded view but when i clicked on "Edit Position", the view did not explode. Everything was gone. And drawing was mixed up as well.

It was very complicated exloded view. I don't want to try to make it again.

So how can i bring it back?