cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Have a PTC product question you need answered fast? Chances are someone has asked it before. Learn about the community search. X

orientation in assembly family table

JHowell
1-Newbie

orientation in assembly family table

Hello. I am trying to orient same part in two or more assembly instances, but with different orientations. Any suggestions?


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
1 ACCEPTED SOLUTION

Accepted Solutions

Do you really need to make the distinction in the family table?

However, a couple ideas:

  • assemble the part, be sure to use an axis so that one of your constraints allows for an angular offset constraint. Then in your family table add this dimension value for the orientation shift
  • another idea is to leverage flexible components. Assemble the object and use flexible component interface to modify the alignment angle value.

Similar concepts, you just need to get an editable value for the family table.

If you can illustrate your requirement a bit better, visually, it may help as well.

View solution in original post

5 REPLIES 5
chris5
1-Newbie
(To:JHowell)

Hi

I copie the part in the second assembly instance. (open the part from the first assembly instance while the second is your working directory and "save a copy"). If you have made the drawing it will come with if it has the same name.

Let us know if this works for you or if it is that what you were looking for.

Regards

Chris

JHowell
1-Newbie
(To:chris5)

I want to have only 1 model of part; with it in a first assembly table instance, then orient the part 180 degrees in a second assembly table instance.

Thanks, Jack

Do you really need to make the distinction in the family table?

However, a couple ideas:

  • assemble the part, be sure to use an axis so that one of your constraints allows for an angular offset constraint. Then in your family table add this dimension value for the orientation shift
  • another idea is to leverage flexible components. Assemble the object and use flexible component interface to modify the alignment angle value.

Similar concepts, you just need to get an editable value for the family table.

If you can illustrate your requirement a bit better, visually, it may help as well.

Jason

Thanks,

I used the first part of your solution and it was successful.

Jack

Assemble the component in the first orientation, and Suppress it. Assemble the component in the second orientation. Each of these is a separate numbered component in the assembly even though they are the same Part. You then add a column for each component to your Family Table, and enter Y or N depending on which one you want to be present in a particular instance.

Top Tags