cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Creo View: Multi-byte characters are not supported for NX PMI conversion

Highlighted
Marble

Creo View: Multi-byte characters are not supported for NX PMI conversion

Need an improvement in NX PMI conversion for the Multi-byte character in the future release of Creo View and Creo View adapter for NX.

Based on the comments in the chapter of Supporting NX with Model View States in 5.1 F000 Crreo View MCAD Adapters Installation and Configuration Guide

  • NX PMI conversion has the following limitations: No Multi-byte character support. Only ASCII characters in PMI annotations are converted.

 

1 REPLY 1

Re: Creo View: Multi-byte characters are not supported for NX PMI conversion

You can bring your idea in "Creo Ideas" area, here: https://community.ptc.com/t5/Addtl-Creo-Ideas-Creo-View/idb-p/creogeneralideas