cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - You can subscribe to a forum, label or individual post and receive email notifications when someone posts a new topic or reply. Learn more! X

Hatching on Creo View

Florian94
7-Bedrock

Hatching on Creo View

Hello everyone !

 

I think it could be great to enable Creo View to display hatching on a section. This is something widely used on the industry and really important for the Model Based Design.

 

Is there any enhancement on this subject ?

 

Have a nice day 🙂

4 REPLIES 4

If you are under maintenance check https://support.ptc.com/apps/solution_preview/solution/lang/presolution?lang=en&n=CS208090 I am not, so am limited to the problem description.

Thank you for your answer !

 

At the end of the article it's explained that Cross-Hatch is exported (in .pvz) as a "Cosmetic Geometry". But Cosmetic Sketch Properties is not supported by Creo View Adapters ..

 

So it seems there isn't any solution .. unless PTC enable Creo View to read Cometic Properties..

VeqTor
12-Amethyst
(To:Florian94)

It is a severe limitation that sections can not be hatched in Creo View.

 

This feature really should be added. 

romorrison
12-Amethyst
(To:VeqTor)

The idea to support this enhancement has been created here:

 

https://community.ptc.com/t5/Addtl-Creo-Ideas-Creo-View/Hatching-on-Creo-View/idi-p/558431

 

It would be good to up vote this if you feel it's an important enhancement.

Top Tags