I would like know, how Pro/web.link works.
if possible, someone could show me how increase my engineering tasks.
thanks in advance
I hope someone with specific Web/Link knowledge chimes in. This tool has some cool possibilities but unfortunately the documentation is sketchy.
It's one of those packages that works well... once you play with it and figure out how it works. Of course... there's no one who can tell you or show you how it works!
Sadly there are quite a few of these nifty tools that scarely anyone uses due to poor documentation and lack of training. I've started it half a dozen times only to give up because there are too many moving parts. I'll be interested in seeing if anyone else comes forward to help.
Thanks... and good luck!
I have 5 years experience of Pro/weblink and I think its not so difficult.
I didint have any programing skills when I started, but I have built more than 50 tools.
You have to do 2 things below when you use weblink tools.
2. set your interner explorer security setting to "low"
for further information, you should see <proe loadpoint>/weblink/weblinkug.pdf
It doesn't write all so if you have any questions, contact me at firstname.lastname@example.org
I know this is an old post... but hopefully this is better late than never.
If you want to learn about Pro/WEBLINK, I think the best resource is the book "Design Automation and Pro/Web.Link". See http://proetoolbox.co.uk. The book is by Chris Lewis, a former PTC employee who self published on lulu. http://www.lulu.com/shop/christopher-lewis/a-proengineers-guide-to-proweblink/paperback/product-2175...
(I should mention: I have the 1st edition and that's what my comments are based on. I see there is a new edition that was updated for Creo.)