Bend Allowance for SS
‎Feb 01, 2010
02:35 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
‎Feb 01, 2010
02:35 PM
Bend Allowance for SS
Hi Folks,
Just asking if anybody would be willing to share their thoughts on bend
details for 316L Annealed SS?
We are going to be air bending 10 gauge (.135) with 3/4" V dies, this
combination is a bit off the charts so I'm anticipating it might not
conform to one of the standard bend tables.
BTW, which bend table would normally be used for 316L SS?
Thanks!
Regards,
Walt Weiss
Just asking if anybody would be willing to share their thoughts on bend
details for 316L Annealed SS?
We are going to be air bending 10 gauge (.135) with 3/4" V dies, this
combination is a bit off the charts so I'm anticipating it might not
conform to one of the standard bend tables.
BTW, which bend table would normally be used for 316L SS?
Thanks!
Regards,
Walt Weiss
1 REPLY 1
‎Feb 01, 2010
06:31 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
‎Feb 01, 2010
06:31 PM
I don't know if this helps but I havesome min bend radiifor 302 on my old TAD slide rule:
Michael R. Jenkins P.E.
Design Engineer
Direct: 816-801-2332
Fax: 816-891-9432
Commercial Vehicle Systems
Haldex Brake Products Corporation
10930 North Pomona Avenue
Kansas City, MO 64153-1215
Michael R. Jenkins P.E.
Design Engineer
Direct: 816-801-2332
Fax: 816-891-9432
Commercial Vehicle Systems
Haldex Brake Products Corporation
10930 North Pomona Avenue
Kansas City, MO 64153-1215