cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Learn all about PTC Community Badges. Engage with PTC and see how many you can earn! X

Bevel Gears not turning at the same speed.

fphelps
1-Newbie

Bevel Gears not turning at the same speed.

Hello All,

Another question. I have setup two bevel gears I can get them to run, and also in the right direction. However I cannot get them to go at the same speed without applying a servo motor to both gears. Is there some way around this to only apply one servo motor, or are two servos a must? Thanks in advance for the help.

1 ACCEPTED SOLUTION

Accepted Solutions

Yep, use the generic gear connection.

See attached (Creo 2.0 full version)

View solution in original post

4 REPLIES 4

Mechanism may be using the reference axes to determine the ratio. You need to set this to user ratio. Bevel gears act a little different behind the scenes than spur gears. With spur gears, I can set whatever ration I want under a user definition.

Thanks for the reply Antonius. Could you please explain where and how I set it to the "user ratio". Thanks.

Yep, use the generic gear connection.

See attached (Creo 2.0 full version)

Thank you sir!

Announcements
Business Continuity with Creo: Learn more about it here.

Top Tags