Community Tip - Did you know you can set a signature that will be added to all your posts? Set it here! X
Last evening i was solving a 3 X 3 Rubik's cube and it thus came in my mind "If it was even possible to make a completely working Rubik's cube in any version of Creo?" If it is already made, give me the link please. If it hasn't, experts wanna try some hands on it?
Solved! Go to Solution.
Hello yogesh,
Here's a thread about this very subject:
http://communities.ptc.com/message/172419#172419
It sounds like a fully functioning click-and-drag model isn't possible. You could fake it like in this video made by Vladimir.
Hello yogesh,
Here's a thread about this very subject:
http://communities.ptc.com/message/172419#172419
It sounds like a fully functioning click-and-drag model isn't possible. You could fake it like in this video made by Vladimir.
much appreciated reply