cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - You can subscribe to a forum, label or individual post and receive email notifications when someone posts a new topic or reply. Learn more! X

Copy and Publish Geometry

fgallagher
4-Participant

Copy and Publish Geometry

Ok, I am trying to model a stiffener between the two grey gussets shown below.

Copy_Publish_Geoms.JPG

I want to be able to use the inside of the gussets as references along with the red and orange plates. I am obviously a little confused on how to use Copy and Publish Geometry features in Creo. My counterparts did this using "Geometry Backup" shown below.

Copy_Publish_Geoms_1.JPG

How do I do the Geometry Backup shown for this stiffener? Thanks!

1 ACCEPTED SOLUTION

Accepted Solutions
fgallagher
4-Participant
(To:fgallagher)

I figured it out, those are referenc lines from Sketcher. They create the Geometry Backup when you activate the part in the assembly and create your sketch from there.

View solution in original post

1 REPLY 1
fgallagher
4-Participant
(To:fgallagher)

I figured it out, those are referenc lines from Sketcher. They create the Geometry Backup when you activate the part in the assembly and create your sketch from there.

Announcements
Business Continuity with Creo: Learn more about it here.

Top Tags