Community Tip - You can Bookmark boards, posts or articles that you'd like to access again easily! X
Okay...I know this is the CAD forum...not the rant section....but I cannot hold it back any longer. The new draft analysis is truly horrible. Slow, cumbersome, un-imformative and a PAIN to use.
PTC,
I know I can "save" an analysis....but I simply don't want it required of me to do that to have functionality that used to exist and worked fine previously.
end rant.
Similarly, I’ve long created skeleton models in an assembly
where I create a master surface with parting surfaces (non-planer parting).
These parting surfaces were used in creating the component parts that make up
the assembly. Creo 2, even with “Mold Design” does not allow the creation of a silhouette
curve, so important in creating these parting surfaces, in a skeleton model.
They claim the creation of surfaces with silhouette curves in a skeleton model
is not best practices without explaining why.
Really!?
Ross H. Liberty
President, Factory Pipe