Creo 4.0 - Drawing - only single dimenson selection

[SJI]

Hello all together,

Example: in Drawing Modus

In Creo 2.0, when i create dimension by dimension then i lay down, they selected all the dimenson i created and i can select tolerance 4 all these selected dimension´s.

Now in Creo 4.0

They only select the last dimension i created.

See attached Video

I know that i can select all with a window, but if there some diameter between i select it too.

Thanks 4 help.

cheers 

Stephan

[Mahesh_Sharma · Accepted solution]

A new config has been introduced ( in Creo 4.0 M040) to get this as in earlier versions, set select_newly_created_dims to yes.

Check article  CS272125