cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X

Translate the entire conversation x

File size in Creo 1.0 Parametric M010 & M020

Go to solution
BrentRMeyer
7-Bedrock
7-Bedrock
‎Dec 19, 2011 09:14 AM
‎Dec 19, 2011 09:14 AM

File size in Creo 1.0 Parametric M010 & M020

Has anyone noticed an increase in file size when moving from Wf 5.0 to Creo 1.0 Parametric M010 & M020? Some of my models have grown by a factor of 10 and has caused my PC to use up all 8Gig of RAM and files sizes of in the range of 400mb to 2 gig. Anyone have any ideas.

Thanks

0 Kudos
Notify Moderator
ACCEPTED SOLUTION

Accepted Solutions
BrentRMeyer
7-Bedrock
7-Bedrock
(To:BrentRMeyer)
‎Dec 20, 2011 07:47 AM
‎Dec 20, 2011 07:47 AM

Well I think I found the problem. The config.pro had mutiple entries for "tol_mode nominal". I ran Creo without my config.pro and the file sizes went back to normal. I guess I had better clean up my config.pro with new versions from here on out.

Thanks

View solution in original post

0 Kudos
Notify Moderator
1 REPLY 1
BrentRMeyer
7-Bedrock
7-Bedrock
(To:BrentRMeyer)
‎Dec 20, 2011 07:47 AM
‎Dec 20, 2011 07:47 AM

Well I think I found the problem. The config.pro had mutiple entries for "tol_mode nominal". I ran Creo without my config.pro and the file sizes went back to normal. I guess I had better clean up my config.pro with new versions from here on out.

Thanks

0 Kudos
Notify Moderator
Announcements
Business Continuity with Creo: Learn more about it here.

Top Tags