cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

Community Tip - You can Bookmark boards, posts or articles that you'd like to access again easily! X

Pro Engineer 2.0 and Pro Engineer 3

ptc-2116920
1-Visitor
1-Visitor
‎Sep 17, 2008 09:24 PM
‎Sep 17, 2008 09:24 PM

Pro Engineer 2.0 and Pro Engineer 3

How do you open files created by Pro Engineer 3 in Pro Engineer 2 ? Is it even possible?
0 Kudos
Notify Moderator
3 REPLIES 3
ptc-2127864
1-Visitor
1-Visitor
(To:ptc-2116920)
‎Sep 17, 2008 10:28 PM
‎Sep 17, 2008 10:28 PM

Loo Monford. What you say that you want to open a pro-wf3 file in wf2 version i would say that it's not possible becuse in pro-e it don't allow you to open any file of higher version(wf3) in lower version(wf2)but if you despertely needed then you can make a IGS file in (WF3)& then open it in wf2 i think it may work. Regards Abhaya
0 Kudos
Notify Moderator
DavidButz
12-Amethyst
12-Amethyst
(To:ptc-2127864)
‎Sep 17, 2008 11:48 PM
‎Sep 17, 2008 11:48 PM

Loo, Check the following link for the free download allowing the backward compatability you are looking for: http://www.ptc.com/products/granite/gcri/index.htm David
0 Kudos
Notify Moderator
ptc-2146431
1-Visitor
1-Visitor
(To:DavidButz)
‎Sep 27, 2008 04:14 PM
‎Sep 27, 2008 04:14 PM

I have almost the same question. My school uses V3.0 education edition and if I buy V4.0 education edition would I still be able to open the V4.0 files in the V3.0 machine? The link that David gave only specified V4.0 and V2.0.
0 Kudos
Notify Moderator
Announcements
Business Continuity with Creo: Learn more about it here.

Top Tags