Solidify :(
‎Aug 11, 2015
07:50 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
‎Aug 11, 2015
07:50 AM
Solidify :(
Hello Friends,
I am working on creating a flow model for a hydraulic motor & it is the first time I am doing it. I could extract the surfaces from the required flow path but unable to solidify, since the surfaces are coming from 2 different parts & I need to merge them. Could anybody guide me on this. Attached are the reference pictures.
2 REPLIES 2
‎Aug 11, 2015
08:03 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
‎Aug 11, 2015
08:03 AM
Try to attach the original asm(2 parts).
I think that your part is not connected correctly.
Best Regards,
Vladimir Palffy
Vladimir Palffy
‎Aug 11, 2015
08:42 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
‎Aug 11, 2015
08:42 AM
Couple of ways you might do this. Place those parts and a new empty part into an assembly. Merge all the geometry from those two into the empty one. Using that same assembly as a starting point you could also do copy geoms from your parts into the empty one. Do all your/merge & solidify in new part.