TDO and EMX
Nov 13, 2008
10:12 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Nov 13, 2008
10:12 AM
TDO and EMX
Hello Nuno, There are also trainings and tutorials on TDO available in PTC.com, however I strongly recomend that you check out PTC University. There you can find courses that may help you with all of PTC products. ________________________ Agora em PT Olá Nuno, Existem disponÃveis tutoriais sobre o TDO e EMX disponiveis no site da PTC, no entanto, recomendo vivamente uma visita à PTC University. É basicamente uma Universidade online com cursos acerca de todos os produtos PTC.
6 REPLIES 6
Nov 13, 2008
10:17 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Nov 13, 2008
10:17 AM
I'm sorry. this was supposed to by a reply to the topic "MOLD DESIGNING" posted by Nuno Mendes.
Nov 13, 2008
10:48 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Nov 13, 2008
10:48 AM
hey im happy to see somebody of portugal in the forum, but, is TDO used there in the north?? whe only use EMX?? is it rentable??? im going to take a look at the tutorials and the university!!
Nov 13, 2008
11:36 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Nov 13, 2008
11:36 AM
Olá Nuno, Se me puder dar o seu email, envio-lhe alguma informação sobre o TDO e EMX.
Nov 13, 2008
01:06 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Nov 13, 2008
01:06 PM
"Jose Vidal" wrote:
Olá Nuno, Se me puder dar o seu email, envio-lhe alguma informação sobre o TDO e EMX.
Nov 17, 2008
03:23 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Nov 17, 2008
03:23 AM
É a mesma coisa! O modulo que vocês têm, provavelmente, é o Complet Mold Design, que já inclui o TDO (que é o mfg - mold cavity). http://www.ptc.com/WCMS/files/29008/en/1947_ToolDes_DS.pdf
Nov 17, 2008
10:31 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Nov 17, 2008
10:31 AM
"Gonçalo Duarte" wrote:
É a mesma coisa! O modulo que vocês têm, provavelmente, é o Complet Mold Design, que já inclui o TDO (que é o mfg - mold cavity). http://www.ptc.com/WCMS/files/29008/en/1947_ToolDes_DS.pdf