Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X
Hello !
I would like to change the unit measurement in "millimètre newton seconde".
The configure write "Acces denide" and I don't understand what I must do.
Can you help me please ?
Thank you !
P.S: I'm french
Solved! Go to Solution.
Unit conversion is done at the part/assembly level within Creo.
File>Prepare>Model Properties>Units - change
Unit conversion is done at the part/assembly level within Creo.
File>Prepare>Model Properties>Units - change