eDrawings for WF5?

[BrentDrysdale]

Hi Folks,
We are gettinmg ready to change over to WF5 M040. One question is if
eDrawings will support WF5. Looking at the eDrawings site it sems that it
still only goes up to WF4. Anybody know anything different?


Regards, Brent Drysdale
Senior Mechanical Designer
Tait Radio Communications
New Zealand
DDI +64 3 358 1093
www.taitradio.com

[fred_roy]

Hi Brent,



I just tried with both .drw and .prt and it doesn't work. I'm running
version 10.2.0.122 of eDrawings.



Regards,

Fred

[mjenkins]

Just my opinion, but the 3D pdf that can be put out from WF4 and up makes EDrawings obsolete.

Michael R. Jenkins P.E.
Design Engineer
Direct: 816-801-2332
Fax: 816-891-9432

Commercial Vehicle Systems
Haldex Brake Products Corporation
10930 North Pomona Avenue
Kansas City, MO 64153-1215

[TimothyWells]

We use Edrawings with WF5 M030/M040 and have no issues. Works very well in fact.

Tim Wells
In Reply to Brent Drysdale:

Hi Folks,
We are gettinmg ready to change over to WF5 M040. One question is if
eDrawings will support WF5. Looking at the eDrawings site it sems that it
still only goes up to WF4. Anybody know anything different?


Regards, Brent Drysdale
Senior Mechanical Designer
Tait Radio Communications
New Zealand
DDI +64 3 358 1093
www.taitradio.com

[PeterChristoffe]

Hi Brent,

We chaged to WF5 M030 2 weeks ago and are running eDrawing 2010 SP1 version 7.1 [7.1.0.107].
Furthermore a installation of Microsoft C++ is needed. Free download from this link :