A 3d sketch tool would be great. i usually use this tool in SW to draw in wires with a spline. much easier than drawing 2 sketches on different planes and combining them.
I think the real link should be https://community.ptc.com/t5/Creo-Ideas/3D-Sketch-in-part-mode/idi-p/461089
Unfortunately a lot of links were lost during the forum migration
Oh and Toby is no longer with us...https://community.ptc.com/t5/Community-Announcements/Community-Changes/ba-p/483645
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.