Get Help

Turn on suggestions

Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.

Showing results for

- Community
- :
- Creo Ideas
- :
- Creo Parametric Ideas
- :
- Allow Parameters to be included in Superscript and...

Options

- Subscribe to RSS Feed
- Mark as New
- Mark as Read
- Bookmark
- Subscribe
- Email to a Friend
- Printer Friendly Page
- Notify Moderator

Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.

Showing results for

Allow Parameters to be included in Superscript and Subscript text syntax

Add ability for use of parameters in the Superscript and Subscript text syntax **@+<param_name>@# **and **@-<param_name>@#**

This would be very useful for custom hole charts with hole callout notes when certain hole sizes have non-symmetric tolerances.

For example the tap drill for a #4 helical insert is a #31 drill, .120" diameter. Allowed minor diameter per NASM spec (rounded to 3 place decimals) is .118"-.125". So the preferred hole callout would be .120+.005/-.002. This uses the standard tap drill and the tolerance range permitted per the NASM spec. When displaying this hole callout on a drawing or model annotation we would typically stack the tolerances (i.e. +.005 over the -.002) in super/subscript. This is currently not possible when the hole sizes and tolerances are entered into the hole chart as parameters, since the Superscript and Subscript syntax above only allows plain text.

See more ideas labeled with:

4 Comments

You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.