cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

The PTC Community email address has changed to community-mailer@ptc.com. Learn more.

Creo Simulate - Snap Through for Contact Analyses

Creo Simulate - Snap Through for Contact Analyses

Status: Archived Submitted by 5-Regular Member on ‎May 23, 2018 10:50 AM
1 Comment (1 New)

Currently, Creo Simulate can run Large Deformation Snap Through Analyses (Non-linear Stability) e.g. a cup spring under load, but Contact is not supported for a Snap Through analysis. 

 

There are cases where Contact + Snap Through are beneficial (e.g. if you want to simulate a plastic buckle/snap fit where 2 plastic parts slide past each other and snap into place).

 

Can PTC please enable Snap Through + Contact Analyses to be run in Creo Simulate?

See more ideas labeled with:
1 Comment
olivierlp
Community Manager
Community Manager
‎Jul 05, 2022 08:39 AM
‎Jul 05, 2022 08:39 AM
Status changed to: Archived

Hello,

We are archiving your idea as part of a general review. This action is based on the age of your idea and the total number of votes received, as per this announcement.

You can always post a new idea with all the details required in the form.

Thank you for your participation.