cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Deafult units to millimeter

Deafult units to millimeter

Creo should have an option to install millimeter templates ( as default)  while doing installation of the software.

During the trial,  its often confuses new users a lot.

Obviously, now we got  'creo_standards folder', but will not help always especially if the user privileges are very limited.

4 Comments
LukaszMazur
16-Pearl

PTC did it once, with Wildfire 5.0, where you could choose during installation which templates you'd use. Strangely, it was removed in Creo 1.0 and didn't come back.

fmueller
3-Visitor

I would even go further. As PTC wants to sell it's product on the global market, it should work with the international stantdards ISO and in the SI-units by default. But I'm afraid that's another question. On the global market many things would be much easier if there woulnd't be the imperial unit system anymore. Even in the united Kingdom they managed it to work (at least in wide parts) in metric system.

PTCModerator
Emeritus
Status changed to: Acknowledged
 
olivierlp
Community Manager
Status changed to: Archived

Hello,

We are archiving your idea as part of a general review. This action is based on the age of your idea and the total number of votes received, as per this announcement.

You can always post a new idea with all the details required in the form.

Thank you for your participation.