Enable selection of Datum points in Model tree

[JWayman]

WF2

When I want to Publish Geometry, I can select Datum Planes, Datum Curves, Surfaces, etc. by clicking on the specific item in the Model Tree. Not Datum Points, though. I can only select them by clicking on the point in the model window.

Minor, yes, but irritatiing.

[Chris3]

FYI I placed a call with PTC about this a long time ago and they said they reason it wasn't implimented like that is because you can have multiple datum points in a single datum point feature. In the case of multiple points, which one do you choose?

If you say well turn it on if there is only 1 datum point in that feature then it becomes confusing when it works for some and not all.