cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

The PTC Community email address has changed to community-mailer@ptc.com. Learn more.

Modelcheck: Checking subcomponents in assembly for proper parameters

Modelcheck: Checking subcomponents in assembly for proper parameters

Status: New Idea Submitted by 16-Pearl on ‎Oct 13, 2020 02:01 PM
2 Comments (2 New)

As a request by @lwestbrook, I am breaking up the massive Modelcheck idea thread here:

https://community.ptc.com/t5/Creo-Parametric-Ideas/New-ModelCheck-Ideas/idc-p/692247#M13722

 

For this idea use modelcheck for checking subcomponents in assembly for proper parameters (windChill location, based on naming convention and release state) including component level parameters, like line numbers, etc.

See more ideas labeled with:
2 Comments
lhoogeveen
17-Peridot
17-Peridot
‎Oct 19, 2020 08:06 AM
‎Oct 19, 2020 08:06 AM

Somewhat related idea: https://community.ptc.com/t5/Creo-Parametric-Ideas/ModelCheck-Assembly-Component-Not-Allowed/idi-p/618800

jwagh
16-Pearl
16-Pearl
‎Oct 19, 2020 10:31 AM
‎Oct 19, 2020 10:31 AM

upvoted your idea. You are right, very similar.